REASSEMBLY
Removal / installation · Vehicles built from Jan 2006
| 1. INSTALL FRONT AXLE HUB BEARING |
![]() ![]() |
Using SST and a press, insert a new hub bearing, with its magnetic rotor side facing the inside of the vehicle, until it reaches the end of the steering knuckle.
- SST
- 09950-60020
(09951-00710)
09950-70010 (09951-07100)
- NOTICE:
- Do not remove the inner race because the hub bearing is built into the oil seal.
- Do not use bearings that have been removed.
- Do not wipe off any grease that has been applied to new bearings.
- Do not bring magnets close to the magnetic rotor surface of the bearing.
- Keep the magnetic rotor surface of the bearing free of foreign matter.
- Do not remove the inner race because the hub bearing is built into the oil seal.
| 2. INSTALL FRONT DISC BRAKE DUST COVER |
![]() ![]() |
Provisionally install a new disc brake dust cover, as shown in the illustration.
Using SST and a hammer, install the disc brake dust cover.

- SST
- 09223-56010
- NOTICE:
- Uniformly press in the disc brake dust cover while sliding SST slightly.
- Surely press in the disc brake dust cover until it comes into contact with the pressing-in base.
- Uniformly press in the disc brake dust cover while sliding SST slightly.
Using a chisel, fix the 3 points on the circumference.

- NOTICE:
- Securely fold each end into the engagement grooves.
| 3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY |
![]() ![]() |
Using SST and a press, press the axle hub into the steering knuckle.
- SST
- 09608-32010
09950-60010 (09951-00500)
09950-70010 (09951-07100)
| 4. INSTALL FRONT AXLE HUB HOLE SNAP RING |
![]() ![]() |
Using snap ring pliers, install a new hole snap ring, as shown in the illustration.
- NOTICE:
- Do not overlap the end of the snap ring and the installation hole in the speed sensor on the knuckle side.
- Do not damage the magnetic rotor surface of the bearing when installing the snap ring.
- Do not overlap the end of the snap ring and the installation hole in the speed sensor on the knuckle side.




