2005-2008 Yaris · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built from Aug 2005


1. INSTALL REAR AXLE HUB BOLT

C112166E01
  1. Install the washer and the nut onto a new hub bolt as shown in the illustration.

  1. Using a screwdriver or the equivalent to hold the hub and bearing, install the hub bolt by tightening the nut.


2. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY (for Rear Drum Brake)

3. ADJUST REAR DRUM BRAKE SHOE CLEARANCE (for Rear Drum Brake)

F040023E03
  1. Provisionally install the 2 hub nuts.

  1. Remove the hole plug, and turn the adjuster to expand the shoe until the drum locks.

  1. Using a screwdriver, release the adjuster 12 notches.

  1. Install the hole plug.


4. INSTALL REAR DISC (for Rear Disc Brake)

C108951E01
  1. Align the matchmarks of the disc and axle hub and install the disc.

    NOTICE:
    When replacing the disc, select the position that gives the minimum disc runout.


5. INSTALL REAR DISC BRAKE CYLINDER MOUNTING (for Rear Disc Brake)

C108950
  1. Install the disc brake cylinder mounting onto the axle beam with the 2 bolts.

    Torque:
    57 N*m{ 585 kgf*cm , 42 ft.*lbf }


6. INSTALL REAR DISC BRAKE PAD KIT (PAD ONLY) (for Rear Disc Brake)

C108945
  1. Install the 2 disc brake pads onto the disc brake cylinder mounting.

    NOTICE:
    There should be no oil or grease on the friction surfaces of the disc brake pads or the rear disc.


7. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY (for Rear Disc Brake)

C107573
  1. Install the disc brake cylinder with the 2 bolts.

    Torque:
    34 N*m{ 350 kgf*cm , 25 ft.*lbf }


8. CONNECT PARKING BRAKE CABLE ASSEMBLY (for Rear Disc Brake)

C108942
  1. Install the casing cap clip onto the rear disc brake cylinder guide.

  1. Connect the cable end to the rear disc brake cylinder operation lever.


9. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }

← REMOVAL (from Aug 2005)COMPONENTS (from Nov 2005) →