2005-2008 Yaris · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL REAR AXLE HUB BOLT

C130310E01
  1. Install the washer and the nut onto a new hub bolt as shown in the illustration.

  1. Using a screwdriver or the equivalent to hold the hub and bearing, install the hub bolt by tightening the nut.


2. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY (for Rear Drum Brake)

3. INSTALL REAR DISC (for Rear Disc Brake)

C108951E01
  1. Align the matchmarks of the disc and axle hub and install the disc.

    NOTICE:
    When replacing the disc, select the position that gives the minimum disc runout.


4. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY (for Rear Disc Brake)

C130313
  1. Install the disc brake caliper onto the rear axle beam.

    Torque:
    57 N*m{ 585 kgf*cm , 42 ft.*lbf }


5. CONNECT PARKING BRAKE CABLE ASSEMBLY (for Rear Disc Brake)

C129770
  1. Install the casing cap onto the rear disc brake cylinder guide.

  1. Connect the cable end to the rear disc brake cylinder operation lever.


6. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }

← REMOVAL (from Nov 2005)COMPONENTS (from Jan 2006) →