REMOVAL
Removal / installation · Vehicles built Aug 2005 – Dec 2005
Versions by build date: Aug 2005 – Dec 2005 from Jan 2006
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) |
| 3. REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY (for Manual Transaxle) |
![]() ![]() |
Disengage the 6 claws and remove the shifting hole cover.
| 4. REMOVE CONSOLE BOX REAR COVER |
![]() ![]() |
Disengage the 8 claws and remove the console box rear cover.
| 5. REMOVE CONSOLE BOX ASSEMBLY REAR |
![]() ![]() |
Remove the bolt and disengage the 2 clips to remove the console box.
| 6. REMOVE HEATED OXYGEN SENSOR (for Unleaded Gasoline Specification Vehicle) |
Disconnect the sensor connector.
Remove the grommet and pass the sensor connector out of the cabin through the floor panel.
Using SST, remove the heated oxygen No. 2 sensor.

- SST
- 09224-00010
| 7. REMOVE EXHAUST PIPE ASSEMBLY FRONT (for Unleaded Gasoline Specification Vehicle) |
Remove the 4 bolts and 4 compression springs.
Remove exhaust pipe support No. 4 and exhaust front pipe assembly.


Remove the 2 exhaust pipe gaskets.
| 8. REMOVE EXHAUST PIPE ASSEMBLY FRONT (for Leaded Gasoline Specification Vehicle) |
Remove the 4 bolts and 4 compression springs.
Remove exhaust pipe support No. 4 and the exhaust front pipe assembly.


Remove the 2 exhaust pipe gaskets.
| 9. REMOVE EXHAUST PIPE ASSEMBLY TAIL |
Remove the 2 exhaust pipe support No. 4 and the exhaust tail pipe assembly.





