REMOVAL
Removal / installation · Vehicles built Aug 2005 – Dec 2005
Versions by build date: Aug 2005 – Dec 2005 from Jan 2006
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 2.
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) |
|
| 3.
REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY (for Manual Transaxle)
|
 |
Disengage the 6 claws and remove the shifting hole cover.
| 4.
REMOVE CONSOLE BOX REAR COVER
|
 |
Disengage the 8 claws and remove the console box rear cover.
| 5.
REMOVE CONSOLE BOX ASSEMBLY REAR
|
 |
Remove the bolt and disengage the 2 clips to remove the console box.
| 6.
REMOVE HEATED OXYGEN SENSOR
|
 |
Disconnect the sensor connector.
Remove the grommet and pass the sensor connector out of the cabin through the floor panel.
- Using SST, remove heated oxygen sensor No. 2.
- SST
- 09224-00010
| 7.
REMOVE EXHAUST PIPE ASSEMBLY FRONT |
 |
Remove the 4 bolts and 4 compression springs.
Remove exhaust pipe support No. 4 and the exhaust front pipe assembly.


Remove the 2 exhaust pipe gaskets.
| 8.
REMOVE EXHAUST PIPE ASSEMBLY TAIL |
 |
Remove the 2 exhaust pipe support No. 4 and the exhaust tail pipe assembly.

