2005-2008 Yaris · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.


2. SEPARATE HOOD TO COWL TOP SEAL

  1. E113851
    Disengage the 7 clips and remove the hood to cowl top seal.


3. REMOVE COWL TOP NO. 1 VENTILATOR LOUVER CENTER

  1. A125670
    Disengage the 2 hooks and remove cowl top ventilator louver center No. 1.

  1. Disconnect the washer hose.


4. REMOVE BATTERY

5. REMOVE BATTERY TRAY

6. REMOVE BATTERY CARRIER

7. SEPARATE BRAKE TUBE (w/o VSC)

C116914E01
  1. Using SST, separate the brake tube from the front flexible hose.

    SST
    09023-00100  

  1. C116915E01
    Using SST, separate the 2 brake tubes from the brake tube No. 1 way.
    SST
    09023-00100  

    NOTICE:
    To avoid breakage of the brake tube on the body side, hold the brake tube No. 1 way and remove the brake tube.

  1. C128963E01
    Using SST, separate the 2 brake tubes from the brake master cylinder.
    SST
    09023-00100  

  1. C128964
    Using SST, separate the 6 brake tubes from the brake actuator.
    SST
    09023-00100  

  1. C128965E01
    Use tags or labels to identify the place to reconnect each brake tube.

  1. C116918
    Disconnect the brake tube clamp.


8. SEPARATE BRAKE TUBE (w/ VSC)

C116914E01
  1. Using SST, separate the brake tube from the front flexible hose.

    SST
    09023-00100  

  1. C116915E01
    Using SST, separate the 2 brake tubes from the brake tube No. 1 way.
    SST
    09023-00100  

    NOTICE:
    To avoid breakage of the brake tube on the body side, hold the brake tube No. 1 way and remove the brake tube.

  1. C128963E01
    Using SST, separate the 2 brake tubes from the brake master cylinder.
    SST
    09023-38200  

  1. C128972
    Using SST, separate the 6 brake tubes from the brake actuator.
    SST
    09023-00100  
    09023-38200  

  1. C128973E01
    Use tags or labels to identify the place to reconnect each brake tube.

  1. C116918
    Disconnect the brake tube clamp.


9. DISCONNECT CLUTCH RESERVOIR TUBE (for Manual Transaxle)

C128985
  1. Slide the clip and disconnect the reservoir tube.


10. REMOVE BRAKE MASTER CYLINDER

NOTICE:
Remove the brake master cylinder after depressing the brake pedal several times and bleeding the vacuum pressure from inside the brake booster.

  1. Disconnect the brake fluid level warning switch connector.

  1. C128986
    Remove the 2 nuts and remove the brake master cylinder.

  1. Remove the O-ring from the brake master cylinder.

← COMPONENTS (from Nov 2005)DISASSEMBLY (from Nov 2005) →