2005-2008 Yaris · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from Aug 2005


1. INSTALL BRAKE MASTER CYLINDER KIT
  1. Fix the master cylinder body in a vise between aluminum plates.

    NOTICE:
    Do not overtighten the vise.

  1. C116945E01
    Apply lithium soap base glycol grease to the rubber parts as shown in the illustration.

  1. Install the No. 1 and No. 2 pistons into the master cylinder body.

    NOTICE:
    1. Install the piston straight while being careful not to damage the inside of the cylinder.
    2. Do not damage the lip of the cylinder cup.
    3. w/ VSC:
      Install the No. 2 piston with the pin hole facing upward.

  1. C121687
    w/o VSC:

    1. Push in the piston and install a new gasket and a new piston stopper bolt.

      Torque:
      10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. C121689
    w/ VSC:

    1. Push in the piston and install the straight pin.

      NOTICE:
      Install the straight pin correctly.

  1. C121686
    Install the snap ring using snap ring pliers with the piston pushed in.

    NOTICE:
    Do not scratch the inside of the cylinder body.


2. INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
  1. Install the strainer and filler cap onto the master cylinder reservoir.

  1. Apply lithium soap base glycol grease to the 2 grommets and install them onto the master cylinder body.

  1. Install the master cylinder reservoir onto the master cylinder body.

  1. C116942
    Using a pin punch and hammer, tap in the straight pin.

← INSPECTION (from Aug 2005)INSTALLATION (from Aug 2005) →