2005-2008 Yaris · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.


3. REMOVE FRONT WIPER ARM HEAD CAP (for 1ND-TV)

E107882E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the 2 front wiper arm head caps.


4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH (for 1ND-TV)

HINT:
Use the same procedure as for the RH side.


5. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH (for 1ND-TV)
  1. Operate the wiper, then stop the windshield wiper motor in the automatic stop position.

  1. E107883
    Remove the nut and front wiper arm.


6. REMOVE HOOD TO COWL TOP SEAL (for 1ND-TV)

A125202
  1. Disengage the 7 clips and remove the hood to cowl top seal.


7. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for 1ND-TV)

E113855
  1. Disconnect the washer hose.

  1. Disengage the 10 claws and clip and remove the cowl top ventilator louver sub-assembly.


8. REMOVE COWL TOP VENTILATOR LOUVER LH (for 1ND-TV)

E113856
  1. Remove the clip.

  1. Disengage the 4 claws and remove the cowl top ventilator louver LH.


9. REMOVE FRONT WIPER MOTOR AND LINK (for 1ND-TV)

E107890
  1. Remove the 2 bolts.

  1. Slide the wiper link. Disengage the meshing of the rubber pin, then disconnect the connector and remove the front wiper motor and link.


10. REMOVE NO. 2 COWL TO REGISTER DUCT SUB-ASSEMBLY (for 1ND-TV)

A108951
  1. Disengage the claw and remove cowl to register duct sub-assembly No. 2.


11. REMOVE COWL TOP PANEL OUTER (for 1ND-TV)

A117320
  1. Disengage the wire harness clamp.

  1. A107444
    Remove the 9 bolts and remove the cowl top panel outer.


12. DISCONNECT CLUTCH RESERVOIR TUBE (for Manual Transaxle)

C128990
  1. Slide the clip and disconnect the reservoir tube.


13. REMOVE BRAKE MASTER CYLINDER

NOTICE:
Remove the brake master cylinder after depressing the brake pedal several times and bleeding the vacuum pressure from inside the brake booster.

  1. Disconnect the brake fluid level warning switch connector.

  1. C128991E01
    w/o VSC:

    1. Using SST, separate the 2 brake tubes from the brake master cylinder.

      SST
      09023-00100  

  1. w/ VSC:

    1. Using SST, separate the 2 brake tubes from the brake master cylinder.

      SST
      09023-38200  

  1. C128992
    Remove the 2 nuts and remove the brake master cylinder.

  1. Remove the O-ring from the brake master cylinder.

← COMPONENTS (from Nov 2005)DISASSEMBLY (from Nov 2005) →