REMOVAL
Removal / installation · Vehicles built from Jan 2006
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. DRAIN BRAKE FLUID |
- NOTICE:
- Immediately wash off any brake fluid that comes into contact with any painted surfaces.
| 3. DISCONNECT CLUTCH RESERVOIR TUBE (for Manual Transaxle) |
![]() ![]() |
Slide the clip and disconnect the reservoir tube.
| 4. REMOVE BRAKE MASTER CYLINDER |
- NOTICE:
- Remove the brake master cylinder after depressing the brake pedal several times and bleeding the vacuum pressure from inside the brake booster.
Disconnect the brake fluid level warning switch connector.
Using SST, separate the 2 brake tubes from the brake master cylinder.

- SST
- 09023-00100
Remove the 2 nuts and remove the brake master cylinder.

Remove the O-ring from the brake master cylinder.

