2005-2008 Yaris · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Nov 2005


INSPECT INTEGRATION RELAY

A107023E05
  1. Inspect the AM2 (15A) fuse.

    1. Disconnect the fuse. Using an ohmmeter, measure the resistance of the fuse.

      Standard resistance:
      Tester Connection
      Specified condition
      1 - 2
      Below 1 Ω

  1. Inspect the IG2 relay.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified condition
      B1 - C1
      Below 1 Ω
      B1 - B4
      10 kΩ or higher
      B4 - C1
      10 kΩ or higher
      B1 - B4
      Below 1 Ω
      (Apply battery voltage between terminals B2 and B3)
      B4 - C1
      Below 1 Ω
      (Apply battery voltage between terminals B2 and B3)

      NOTICE:
      While using the battery for inspections, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.

← REMOVAL (from Nov 2005)INSTALLATION (from Nov 2005) →