INSTALLATION
Removal / installation · Vehicles built from Aug 2005
- HINT:
- The procedure listed below is for the LH side. Use the same procedure for both the RH and LH side, unless otherwise specified.
| 1.
INSTALL FRONT NO. 2 SPEAKER ASSEMBLY |
 |
Fit the claw of the speaker bracket into the square hole in the body.
Engage the clip and install the speaker.
- Connect the speaker connector.
| 2.
INSTALL FRONT PILLAR GARNISH
|
 |
- w/ Curtain Shield Airbag:
Remove the piece of cloth or nylon.
- w/ Front No. 2 Speaker:
Insert the hook into the body hole.
Engage the clip and install the front speaker.
- Connect the speaker connector.
- Install the 4 wire harness clamps.
w/ Curtain Shield Airbag:
- Install a new special clip and the clip onto a new front pillar garnish.
Engage the 2 clips and the 2 claws and install the front pillar garnish.
w/o Curtain Shield Airbag:
- Engage the 2 clips and the 2 claws and install the front pillar garnish.
| 3.
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP |
 |
Install the front door opening trim weatherstrip LH.
| 4.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
 |
-
Torque:
- 5.4 N*m{
55 kgf*cm
, 48 in.*lbf
}