TERMINALS OF ECU
System information · Vehicles built from Aug 2005
| CHECK MAIN BODY ECU |




Disconnect the 4B and 4E main body ECU (vehicle rear side) connectors.
Measure the voltage and resistance of the wire harness side connectors.
If the result is not as specified, there may be a malfunction in the wire harness.Standard: Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
BECU (4B-30) - GND1 (4E-17)
L - W-B
Battery (power supply)
Always
10 to 14 V
GND1 (4E-17) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
Reconnect the main body ECU (vehicle rear side) connectors.
Measure the voltage of the wire harness side connectors.
*1: HatchbackStandard voltage: Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
KSW (4D-7) - GND1 (4E-17)
Y - W-B
Key unlock warning switch input
Key inserted
0 V
KSW (4D-7) - GND1 (4E-17)
Y - W-B
Key unlock warning switch input
No key in ignition key cylinder
10 to 14 V
DCTY (4A-21) - Body ground
L - Body ground
Driver side door courtesy switch input
Driver side door closed
10 to 14 V
DCTY (4A-21) - Body ground
L - Body ground
Driver side door courtesy switch input
Driver side door open
0 V
PCTY (4A-24) - Body ground
R - Body ground
Passenger side door courtesy switch input
Passenger side door closed
10 to 14 V
PCTY (4A-24) - Body ground
R - Body ground
Passenger side door courtesy switch input
Passenger side door open
0 V
RRCY (4A-20)*2 - Body ground
L - Body ground
Rear RH door courtesy switch input
Rear RH door closed
10 to 14 V
RRCY (4A-20)*2 - Body ground
L - Body ground
Rear RH door courtesy switch input
Rear RH door open
0 V
RRCY (4A-5)*2 - Body ground
G - Body ground
Rear LH door courtesy switch input
Rear LH door closed
10 to 14 V
RRCY (4A-5)*2 - Body ground
G - Body ground
Rear LH door courtesy switch input
Rear LH door open
0 V
RRCY (4A-5)*3 - Body ground
Y - Body ground
Rear LH and RH door courtesy switch input
Rear LH and RH doors closed
10 to 14 V
RRCY (4A-5)*3 - Body ground
Y - Body ground
Rear LH and RH door courtesy switch input
Rear LH or RH doors open
0 V
BCTY (4A-7)*1 - Body ground
SB- Body ground
Back door courtesy switch input
Back side door closed
10 to 14 V
BCTY (4A-7)*1 - Body ground
SB- Body ground
Back door courtesy switch input
Back side door open
0 V
PRG (D33-17) - Body ground
W - Body ground
Door control receiver output
Transmitter switch ON → OFF (No key in ignition key cylinder, all doors closed)
6 to 7 V → Below 1 V → 6 to 7 V
RDA (D33-16) - Body ground
R - Body ground
Door control receiver input
Transmitter switch ON → OFF (No key in ignition key cylinder, all doors closed)
Below 1 V → 6 to 7 V → Below 1 V
HAZ (4S-17) - Body ground
B - Body ground
Hazard warning light signal
Answer-back ON
Pulse generation
HAZ (4S-17) - Body ground
B - Body ground
Hazard warning light signal
Answer-back OFF
10 to 14 V
*2: 5 Door
*3: Sedan
If the result is not as specified, there may be a malfunction in the wire harness.
| CHECK DOOR CONTROL RECEIVER |


Disconnect the door control receiver connector.
Measure the voltage and resistance of the wire harness side connectors.
If the result is not as specified, there may be a malfunction in the wire harness.Standard: Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
+B (J13-5) - GND (J13-1)
L - W-B
Battery (power supply)
Always
10 to 14 V
GND (J13-1) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
Reconnect the door control receiver connector.
Measure the voltage of the wire harness side connectors.
If the result is not as specified, there may be a malfunction in the wire harness.Standard voltage: Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
PRG (J13-3) - Body ground
W - Body ground
Door control receiver output
Transmitter switch ON → OFF (No key in ignition key cylinder, all doors closed)
6 to 7 V → Below 1 V → 6 to 7 V
RDA (J13-2) - Body ground
R - Body ground
Door control receiver input
Transmitter switch ON → OFF (No key in ignition key cylinder, all doors closed)
Below 1 V → 6 to 7 V → Below 1 V