U0100 Lost Communication with ECM / PCM "A"
Diagnostic trouble codes · Vehicles built from Jan 2006
DESCRIPTION
The combination meter assembly and the ECM exchange signals through the CAN communication system.| DTC No. |
DTC Detecting Conditions |
Trouble Areas |
| U0100 |
When either of following conditions detected:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CONFIRM DTC OUTPUT |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON (do not start the engine) and turn the intelligent tester on.
Clear the stored DTCs by selecting the following menu items on the tester: Body/ Combination Meter/ DTC /Clear.
Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.
Stop the vehicle.
Check for DTCs.
- Result:
Result
Proceed to
DTC output
A
DTC not output
B
|
|
||||
| A | ||
| ||
