2005-2008 Yaris · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2005

NOTICE:
  1. Perform the MAF meter inspection according to the procedures below.
  2. Only replace the MAF meter when the MAF value in the DATA LIST (with the engine stopped) is not within the normal operating range.


CHECK MASS AIR FLOW METER

  1. A117072E02
    Read values using an intelligent tester (MAF).

    NOTICE:
    1. Turn the ignition switch off.
    2. Perform the inspection with the vehicle indoors and on a level surface.
    3. Perform the inspection of the MAF meter while it is installed in the air cleaner case (installed on the vehicle).
    4. During the test, do not use the exhaust air duct to perform suction on the exhaust pipe.


    1. Turn the ignition switch on (do not run the engine).

    2. Turn the tester ON.

    3. Select the following menu items: Powertrain / Engine and ECT / Data List / Primary / MAF.

    4. Wait 30 seconds, and read the values on the intelligent tester.

      Standard condition:
      Less than 0.23 g/sec.

      If the result is not as specified, replace the MAF meter.

← COMPONENTS (from Nov 2005)REMOVAL (from Nov 2005) →