2005-2008 Yaris · Service Manual ENGINE

PRECAUTION

Precautions · Vehicles built from Nov 2005


1.IGNITION SWITCH EXPRESSIONS
  1. The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

    Expression
    Ignition Switch (position)
    Engine Switch (condition)
    Ignition Switch off
    LOCK
    Off
    Ignition Switch on (IG)
    ON
    On (IG)
    Ignition Switch on (ACC)
    ACC
    On (ACC)
    Engine Start
    START
    Start


2.FUEL SYSTEM
A095385E01
  1. When disconnecting the fuel line, fuel will splash. So take the following precautions.

    1. Disconnect the fuel tube

    2. Release the pressure remaining in the fuel tank main tube.

    3. Cover the disconnected fuel tank main tube (fuel tube joint and fuel tube connector) with a vinyl bag to prevent damage and the intrusion of foreign matter.

  2. A063387E02
    Take the following precautions when disconnecting the fuel tube connector.

    HINT:
    The structure of the fuel tube connector is as shown in the illustration.


    1. Check the fuel tube connector and pipe for dirt and mud before removing the fuel tube connector.
      If dirty, wipe it with a shop rag.

    2. A095386E01
      Pinch the tab on the retainer of the fuel tube connector to disengage the lock claws. Push it down as shown in the illustration.

    3. Pull the fuel tank main tube out of the pipe.

    4. A095387
      If the fuel tube connector and pipe are stuck, pinch the pipe, then push and pull the fuel tube connector to release and disconnect the fuel tube connector.

      NOTICE:
      Perform this work by hand. Never use any tools.

    5. After removing the fuel tube, check the sealing surface of the pipe for dirt and mud.
      If dirty, wipe it with a shop rag.

    6. Cover the disconnected fuel tube connector and pipe with a vinyl bag to prevent damage and the intrusion of foreign matter.

  3. A095389E01
    Take the following precautions when connecting the fuel tube connector (quick type A).

    1. Align the fuel tube connector with the pipe, then push the fuel tube connector in until it comes into contact with the seat, then push the retainer up until the claws lock.

    2. A095390E01
      After connecting the fuel tube connector, check that the fuel tube connector and pipe are securely connected by pulling them.


3.CHECK FOR FUEL LEAKAGE
  1. Check that there is no fuel leakage after doing maintenance on the fuel system.Click here

← INSTALLATION (from Nov 2005)PARTS LOCATION (from Nov 2005) →