2005-2008 Yaris · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2005


CHECK ENGINE OIL LEVEL
  1. Warm up the engine. Then stop the engine, and wait 5 minutes.

  1. Check that the engine oil level is between the 2 marks on the oil level gage.
    If low, check for leakage and top up oil to the upper mark.

    NOTICE:
    Do not add engine oil to above the upper mark.


CHECK ENGINE OIL QUALITY

A128761E01
  1. Check the engine oil for deterioration, water intrusion, discoloration and thinning.
    If the oil quality is visibly poor, replace the oil.

    Oil grade:
    Use ACEA B1, API grade CF-4, CF or G-DLD-1.
    (You may also use API CE or CD.)
    SAE 5W-30 is the best choice for your vehicle in terms of good fuel economy and good starting in cold weather.


INSPECT OIL PRESSURE

A125784
  1. Remove the engine under cover.

  1. Disconnect the oil pressure switch connector.

  1. Using a 22 or 24 mm deep socket wrench, remove the oil pressure switch.

    HINT:
    As there are 2 kinds of oil pressure switches, select and use either a 22 or 24 mm deep socket wrench as appropriate.

  1. A125785
    Install the oil pressure gauge.

  1. Warm up the engine.

  1. Check the oil pressure.

    Oil pressure:
    Engine rpm
    Oil pressure
    770 rpm
    29 kPa (0.3 kgf*cm2, 4.3 psi) or more
    3,000 rpm
    150 to 550 kPa (1.5 to 5.6 kgf*cm2, 22 to 80 psi)

  1. Remove the oil pressure gauge.

  1. P013638E06
    Apply adhesive to 2 or 3 threads of the oil pressure switch.

    Adhesive:
    Part No. 08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent

  1. Using a 22 or 24 mm deep socket wrench, install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation.

  1. Connect the oil pressure switch connector.

  1. Check for engine oil leakage.

  1. Install the engine under cover.

← INSTALLATION (from Nov 2005)COMPONENTS (from Nov 2005) →