2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. REMOVE ENGINE UNDER COVER
  1. Remove the 5 bolts, 4 screws and 2 clips and remove the engine under cover.


2. DRAIN ENGINE OIL
  1. Remove the oil filler cap.

  1. Remove the oil drain plug, and drain the oil into a container.

  1. Clean and install the oil drain plug with a new gasket.

    Torque:
    38 N*m{ 387 kgf*cm , 28 ft.*lbf }


3. DRAIN ENGINE COOLANT

CAUTION:
To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.

  1. A125680
    Loosen the radiator drain cock plug.

  1. Remove the reserve tank cap and drain the coolant.

  1. Tighten the radiator drain cock plug.

    A128304E01


4. REMOVE OIL FILTER SUB-ASSEMBLY

  1. A125731
    Turn the knob indicated by the arrow shown in the illustration and open the service cover.

  1. A125723E01
    Using SST, remove the oil filter.
    SST
    09228-07501  


5. REMOVE OIL COOLER ASSEMBLY

  1. G036377
    Disconnect oil cooler hose from the oil cooler.

  1. G036378E01
    Using SST, remove the nut, then remove oil cooler.
    SST
    09229-55010  

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →