2005-2008 Yaris · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. PRECAUTION

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.

3. POSITION FRONT WHEELS FACING STRAIGHT AHEAD

4. REMOVE STEERING PAD (w/o Steering Pad Switch)

C128889E01
  1. Insert a screwdriver 20cm into the hole in the back side of the steering wheel and raise the spring slightly until its release is felt and disengage the lower claw.

  1. C136892
    Push out the steering pad in the direction shown in the illustration and disengage the 2 claws.

  1. C128890E01
    Using a thin-bladed screwdriver, release the locking button.

  1. Using a thin-bladed screwdriver, detach the airbag connector.

  1. Detach the horn terminal.


5. REMOVE STEERING PAD (w/ Steering Pad Switch)

C128888
  1. Insert a screwdriver 20cm into the hole in the back side of the steering wheel and raise the spring slightly until its release is felt and disengage the lower claw.

  1. C136891
    Push out the steering pad in the direction shown in the illustration and disengage the 2 claws.

  1. C128891E01
    Using a thin-bladed screwdriver, release the locking button.

  1. Using a thin-bladed screwdriver, detach the airbag connector.

  1. Detach the horn connector.


6. REMOVE STEERING WHEEL ASSEMBLY

  1. C117210E01
    Remove the nut and place matchmarks on the steering wheel assembly and steering column assembly.

  1. C117207E01
    Using SST, remove the steering wheel assembly.
    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    NOTICE:
    Apply a small amount of grease to the threads and tip of the SST center bolt before using.


7. REMOVE STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)

B108275E01
  1. Disengage the 4 claws and remove the steering column cover support.


8. REMOVE STEERING COLUMN COVER

  1. w/o Entry and Start System:

    1. C118548
      Remove the 3 screws.

    2. Disengage the 2 claws and remove the steering column cover (lower).

    3. Disengage the 2 claws and remove the steering column cover (upper).

  1. w/ Entry and Start System:

    1. C136900
      Remove the 3 screws.

    2. Disengage the 3 claws and remove the steering column cover (lower) and steering column cover support.

    3. Disengage the 2 claws and remove the steering column cover (upper).


9. REMOVE SPIRAL CABLE SUB-ASSEMBLY (w/o Steering Sensor)

B106607E01
  1. Detach the horn connector.

  1. Slide the slider and detach the airbag connector.

  1. C118549
    Disengage the 3 claws and remove the spiral cable.


10. REMOVE SPIRAL CABLE SUB-ASSEMBLY (w/ Steering Sensor)

B109371E01
  1. Detach the horn connector.

  1. Slide the slider and detach the airbag connector.

  1. Detach the steering sensor connector.

  1. B108277E01
    Disengage the 3 claws and remove the spiral cable.


11. REMOVE WINDSHIELD WIPER SWITCH

  1. E113830E01
    Disconnect the 2 connectors.

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the wiper switch.

    NOTICE:
    Do not press the claw too hard, as it may be damaged.


12. REMOVE HEADLIGHT DIMMER SWITCH

  1. E113831
    Disconnect the connector.

  1. Remove the headlight dimmer switch, as shown in the illustration.

  1. E113832E01
    Disengage the 3 claws and remove the headlight dimmer switch.

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →