2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN ENGINE COOLANT

CAUTION:
To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.

  1. A125680
    Loosen the radiator drain cock plug.

  1. Remove the reserve tank cap and drain the coolant.

  1. Tighten the radiator drain cock plug.

    A128304E01


3. REMOVE ENGINE COVER SUB-ASSEMBLY NO. 1

A125743
  1. Disengage the 4 pins and remove engine cover No. 1.


4. REMOVE EGR COOLER ASSEMBLY

  1. A125674
    Disconnect the 2 water by-pass hoses.

  1. Remove the bolt and 4 nuts, then remove the EGR cooler assembly.

  1. Remove the 2 gaskets.


5. REMOVE EGR VALVE ASSEMBLY

  1. A125675
    Disconnect the EGR valve connector and hose.

  1. Remove the 2 nuts, then remove the EGR valve assembly.

  1. Remove the gasket.

← ON-VEHICLE INSPECTION (from Nov 2005)INSPECTION (from Nov 2005) →