2005-2008 Yaris · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Nov 2005

NOTICE:
Turn the ignition switch off for 60 seconds before performing the following procedures.


INSPECT LIGHTING DURATION OF GLOW INDICATOR LIGHT

  1. Turn the ignition switch on (IG) and measure the lighting duration.

    Standard:
    The glow indicator lights in accordance with the engine coolant temperature.

    If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plug and glow plug relay.

    A128775E01


INSPECT PRE-HEATING

A128776E01
  1. Turn the ignition switch to ON and measure how long it takes for the battery voltage to be applied to the glow plugs.

    Standard:
    Engine Coolant Temperature
    Pre-heating Time
    40°C (104°F) or higher
    1 second
    40°C (104°F) or lower
    As indicated in the illustration
    (15 seconds at the longest)

    If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plug and glow plug relay.

  1. Turn the ignition switch to STA and check that the battery voltage is applied to the glow plugs.

  1. While cranking the engine, measure the how long it takes for the battery voltage to be applied to the glow plugs.

    Standard:
    Engine Coolant Temperature
    Pre-heating Time
    40°C (104°F) or higher
    1 second
    40°C (104°F) or lower
    As indicated in the illustration
    (15 seconds at the longest)

    NOTICE:
    Do not start the engine.

    If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plug and glow plug relay.

← SYSTEM DIAGRAM (from Nov 2005)PRECAUTION (from Nov 2005) →