2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE ENGINE UNDER COVER
  1. Remove the 5 bolts, 4 screws and 2 clips and remove the engine under cover.


3. DRAIN ENGINE COOLANT

CAUTION:
To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.

  1. A125680
    Loosen the radiator drain cock plug.

  1. Remove the reserve tank cap and drain the coolant.

  1. Tighten the radiator drain cock plug.

    A128304E01


4. REMOVE ENGINE COVER SUB-ASSEMBLY NO. 1

A125743
  1. Disengage the 4 pins and remove engine cover No. 1.


5. REMOVE FAN AND GENERATOR V BELT

A125681
  1. Remove the 3 bolts and clip, then separate the wire harness.

  1. A098654E01
    Loosen bolts A and B.

  1. Remove the fan and generator V belt.


6. REMOVE GENERATOR ASSEMBLY

A128374
  1. Remove the terminal cap.

  1. Separate the connector and harness clamp.

  1. Remove the nut and remove terminal B.

  1. A128375E01
    Remove fan belt adjusting slider fixing bolt A and nut B and remove the fan belt adjusting slider.

  1. A128376E01
    Remove fixing bolt C and remove the generator.


7. REMOVE FAN BELT ADJUSTING BAR
  1. Remove the nut, then remove the fan belt adjusting bar.


8. REMOVE WATER INLET

  1. A125678
    Remove the 2 nuts, then remove the water inlet.


9. REMOVE THERMOSTAT
← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →