REASSEMBLY
Removal / installation · Vehicles built from Nov 2005
| 1. INSTALL SHIFT STROKE SENSOR |
![]() ![]() |
- NOTICE:
- Be sure to select bolt hole A when installing the shift stroke sensor. Hole B must not be used.
Apply MP grease to a new O-ring.
Install the new O-ring to the shift stroke sensor.
Set the shift stroke sensor so that the sensor arm (sensor side) and the sensor arm (actuator side) are in the position shown in the illustration.

Turn the shift stroke sensor clockwise and fix it with the 2 screws.
- Torque:
- 2.0 N*m{ 20 kgf*cm , 18 in.*lbf }
| 2. INSTALL SELECT STROKE SENSOR |
Apply MP grease to a new O-ring.
Install the new O-ring onto the select stroke sensor.
Set the select stroke sensor so that the sensor arm (sensor side) and the sensor arm (actuator side) are in the position shown in the illustration.

Turn the select stroke sensor clockwise and fix it with the 2 screws.
- Torque:
- 2.0 N*m{ 20 kgf*cm , 18 in.*lbf }

