HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Aug 2005
- HINT:
- The intelligent tester can be used in steps 3, 5 and 6.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| |||||
| 3.DTCS AND FREEZE FRAME DATA CHECK AND CLEARANCE |
| |||||
| 4.PROBLEM SYMPTOM CONFIRMATION |
| Result |
Proceed to |
| Symptom does not occur |
A |
| Symptom occurs |
B |
|
|||||
| |||||
| 5.CAN COMMUNICATION SYSTEM CHECK |
Check for the output DTC relating to the CAN communication system.
- HINT:
- The ECU of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, be sure to check that there is no trouble in the CAN communication system.
Result
Proceed to
CAN communication system DTC not output
A
CAN communication system DTC output
B
|
|||||
| |||||
| 6.DTC CHECK |
- HINT:
- Click here.
| Result |
Proceed to |
| DTC output |
A |
| DTC not output |
B |
|
|||||
| |||||
| 7.DTC CHART |
- HINT:
- Click here.
| |||||
| 8.CIRCUIT INSPECTION |
- HINT:
- When 2 or more DTCs are detected, perform circuit inspections one by one until the problem is identified.
| |||||
| 9.PROBLEM IDENTIFICATION |
| |||||
| 10.REPAIR OR REPLACEMENT |
| |||||
| 11.CONFIRMATION TEST |
| |||||