2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN ENGINE COOLANT

CAUTION:
To avoid the danger of being burned, do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.

  1. A117319
    Install a vinyl hose onto the radiator.

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap sub-assembly.

  1. Loosen the water drain plug, then drain the coolant.

    A128298E01


3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  1. A127144
    Remove the grommet and 2 clamps and remove the air cleaner cap sub-assembly.


4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

5. REMOVE PURGE VSV ASSEMBLY

  1. A127147
    Remove the bolt and remove the purge VSV assembly.


6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

  1. A127148
    Disconnect the mass air flow meter connector.

  1. A127149
    Remove the 3 bolts and remove the air cleaner case sub-assembly.

  1. A127151
    Remove the O-ring from the throttle body assembly.


7. DISCONNECT NO. 1 WATER BY-PASS HOSE

  1. A127150
    Disconnect the 2 No. 1 water by-pass hoses.


8. DISCONNECT NO. 2 VENTILATION HOSE

  1. A127152
    Disconnect the No. 2 ventilation hose from the throttle body assembly.


9. DISCONNECT CHARCOAL CANISTER FUEL HOSE

  1. A127153
    Disconnect the charcoal canister fuel hose from throttle body assembly.


10. REMOVE THROTTLE BODY ASSEMBLY

  1. A127154
    Disconnect the connector from the throttle body assembly.

  1. A127155
    Remove the 3 bolts and remove the throttle body assembly.

  1. A127156
    Remove the O-ring from the intake manifold.


11. DISCONNECT NO. 1 WATER BY-PASS HOSE

  1. A127157
    Disconnect the 2 No. 1 water by-pass hoses from the throttle body assembly.

← ON-VEHICLE INSPECTION (from Nov 2005)INSPECTION (from Nov 2005) →