2005-2008 Yaris · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Jan 2006


1. INSTALL REAR SPOILER PROTECTOR SIDE LH

B134854

NOTICE:
Follow these procedures only when replacing the protector.

  1. Apply a new rear spoiler protector to the rear spoiler installation surface as shown in the illustration.


2. INSTALL REAR SPOILER PROTECTOR SIDE RH

HINT:
Use the same procedure as for the LH side.


3. INSTALL REAR SPOILER SUB-ASSEMBLY

  1. Clean the rear spoiler (When reusing the rear spoiler).

    1. Using an infrared light, heat the double-sided adhesive tape remaining on the luggage compartment door panel.

      HINT:
      Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.

    2. Using a shop rag or piece of cloth, rub the remaining double-sided adhesive tape off the rear spoiler while it is hot from the infrared light.

      NOTICE:
      Installing the rear spoiler while any double-sided adhesive tape remains on the luggage compartment door panel may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.

    3. Using a non-residue solvent, clean the rear spoiler.

    4. B134855
      Apply new double-sided adhesive tape to the rear spoiler installation surface as shown in the illustration.

  1. Clean the attachment surface.

    1. Using an infrared light, heat the double-sided adhesive tape remaining on the luggage compartment door panel.

      HINT:
      Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.

    2. Using a shop rag or piece of cloth, rub the remaining double-sided adhesive tape off the luggage compartment door panel while it is hot from the infrared light.

      NOTICE:
      Installing the rear spoiler while any double-sided adhesive tape remains on the luggage compartment door panel may cause adhesion failure. Therefore, completely remove the double-sided adhesive tape.

    3. Using a non-residue solvent, clean the attachment surface.

  1. B134853
    Install the wire harness into the luggage compartment door panel hole.

  1. Engage the 2 clips and install the rear spoiler.

  1. Remove the protective tape.

  1. B134851
    Tighten the 2 bolts.

  1. Connect the center stop light connector.


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← REASSEMBLY (from Jan 2006)COMPONENTS (from Nov 2006) →