Removal / installation · Vehicles built from Nov 2005
1.
DRAIN ENGINE COOLANT
CAUTION:
To avoid the danger of being burned, do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.
Install a vinyl hose onto the radiator.
Loosen the radiator drain cock plug.
Remove the radiator cap sub-assembly.
Loosen the water drain plug, then drain the coolant.
2.
REMOVE ENGINE UNDER COVER RH
3.
DISCONNECT FAN AND GENERATOR V BELT
Loosen bolts A and B.
Turn adjusting bolt C to release the tension and remove the V belt from the pulleys.
4.
REMOVE WATER PUMP PULLEY
Using SST, hold the water pump pulley.
SST
09960-10010
(09962-01000, 09963-00500)
Remove the 4 bolts and remove the water pump pulley.
5.
REMOVE WATER PUMP ASSEMBLY
Remove the 3 bolts and 2 nuts and remove the water pump assembly.