2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005


1. DISCHARGE FUEL SYSTEM PRESSURE
(Click here)

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  1. A127144
    Remove the grommet and 2 clamps and remove the air cleaner cap sub-assembly.


4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

5. REMOVE PURGE VSV ASSEMBLY

  1. A127147
    Remove the bolt and remove the purge VSV assembly.


6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

  1. A127148
    Disconnect the mass air flow meter connector.

  1. A127149
    Remove the 3 bolts and remove the air cleaner case sub-assembly.

  1. A127151
    Remove the O-ring from the throttle body assembly.


7. DISCONNECT VENTILATION HOSE

  1. A127196
    Disconnect the ventilation hose from the cylinder head.


8. DISCONNECT NO. 2 VENTILATION HOSE

  1. A127197
    Disconnect the No. 2 ventilation hose from the cylinder head.


9. REMOVE ENGINE WIRE HARNESS (for LHD)

  1. A127198
    Disconnect the 4 engine wire harness clamps and the throttle body connector.


10. REMOVE ENGINE WIRE HARNESS (for RHD)

  1. A127199
    Disconnect the 3 engine wire harness clamps and the throttle body connector.


11. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

  1. A127200
    Disconnect the 4 fuel injector connectors.

  1. A127194
    Remove the fuel pipe clamp.

  1. A127202E01
    Pinch the retainer of the fuel tube connector, then pull out the fuel tube connector to disconnect the fuel tube from the fuel delivery pipe sub-assembly.

    NOTICE:
    1. Remove any dirt and foreign matter from the fuel tube connector before performing this work.
    2. Do not allow any scratches or foreign matter on the parts when disconnecting as the fuel tube connector has the O-ring that seals the pipe.
    3. Perform this work by hand. Do not use any tools.
    4. Do not forcibly bend, twist or turn the nylon tube.
    5. Protect the disconnected parts by covering them with vinyl bags after disconnecting the fuel tube.
    6. If the fuel tube connector and pipe are stuck, push and pull to release them.

  1. A127203
    Remove the 2 bolts and remove the fuel delivery pipe sub-assembly and fuel tube together with the fuel injector assembly.

    NOTICE:
    Do not drop the fuel injectors when removing the fuel delivery pipe sub-assembly.


12. REMOVE FUEL INJECTOR ASSEMBLY

  1. A127204
    Remove the 4 injectors from the delivery pipe sub-assembly.

  1. A107004E01
    Remove the O-ring and insulator from each injector.

  1. A127656
    Remove the 2 insulators from the delivery pipe sub-assembly.

← COMPONENTS (from Nov 2005)INSPECTION (from Nov 2005) →