2005-2008 Yaris · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL FAN AND GENERATOR V BELT
  1. Provisionally install the V belt onto the pulleys.


2. INSTALL TRANSVERSE ENGINE ENGINE MOUNTING INSULATOR

A127619
  1. Operate the jack and Install the insulator with the 5 bolts and nut.

    Torque:
    52 N*m{ 530 kgf*cm , 38 ft.*lbf }

  1. A127653
    Install the low pressure pipe stay of the air conditioner with the bolt.

    Torque:
    10 N*m{ 100 kgf*cm , 7 ft.*lbf }


3. ADJUST FAN AND GENERATOR V BELT

A127651E01
  1. Turn adjusting bolt C and adjust the tension of the V-belt.

  1. Tighten fixing bolts A and B.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf } bolt A
    44 N*m{ 449 kgf*cm , 33 ft.*lbf } bolt B


4. INSPECT FAN AND GENERATOR V BELT

A127654E01
  1. Check the V belt deflection and tension.

    Deflection:
    Item
    Specified Condition
    New belt
    7.0 to 8.0 mm (0.28 to 0.31 in) w/ air conditioning system
    4.0 to 5.0 mm (0.16 to 0.20 in) w/o air conditioning system
    Used belt
    9.0 to 9.5 mm (0.35 to 0.37 in) w/ air conditioning system
    6.0 to 6.5 mm (0.24 to 0.26 in) w/o air conditioning system

    Tension:
    Item
    Specified Condition
    New belt
    687 to 883 N (70 to 90 kg, 154 to 199 ld) w/ air conditioning system
    785 to 981 N (80 to 100 kg, 176 to 221 ld) w/o air conditioning system
    Used belt
    539 to 637 N (55 to 65 kg, 121 to 143 ld)

    If the belt deflection is not as specified, adjust it.

    HINT:
    1. Check the V belt deflection at the specified point.
    2. When installing a new belt, set its tension to the specified value.
    3. When inspecting a belt which has been used for over 5 minutes, apply the Used Belt specifications.
    4. When reinstalling a belt which has been used for over 5 minutes, adjust its deflection and tension to the intermediate values of each Used Belt specification.
    5. V-ribbed belt tension and deflection should be checked after 2 revolutions of engine cranking.
    6. When using a belt tension gauge, confirm its accuracy by using a master gauge first.


5. INSTALL ENGINE UNDER COVER RH
← INSPECTION (from Nov 2005)ADJUSTMENT (from Nov 2005) →