2005-2008 Yaris · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL EXHAUST PIPE ASSEMBLY FRONT

  1. A104634
    Using vernier calipers, measure the free length of the compression spring.

    Minimum length:
    40.5 mm (1.594 in.)

    If the length is not as specified, replace the compression spring.

  1. A104635E01
    Using a plastic hammer and a wooden block, tap in a new gasket until its surface is flush with the exhaust manifold.

    NOTICE:
    1. Install the exhaust pipe gasket in the correct direction.
    2. Do not damage the outer surface of the exhaust pipe gasket.
    3. Do not reuse the exhaust pipe gasket.
    4. Do not push in the gasket with the exhaust pipe when connecting it.

  1. Install the 3 No. 4 exhaust pipe supports.

    A128337

  1. Install the exhaust pipe assembly front with the 2 compression springs and 2 bolts.

    Torque:
    43 N*m{ 439 kgf*cm , 32 ft.*lbf }


2. INSTALL EXHAUST PIPE ASSEMBLY TAIL
  1. Install a new gasket onto the exhaust pipe front.

  1. Install the 2 No. 4 exhaust pipe supports.

    A128336

  1. A128338E01
    Install the clamp with the bolt as shown in the illustration.

    Torque:
    32 N*m{ 326 kgf*cm , 24 ft.*lbf }

← REMOVAL (from Nov 2005)COMPONENTS (Aug 2005 – Dec 2005) →