2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2005

NOTICE:
Replace the ECM with a new one if necessary.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT WIPER ARM HEAD CAP

E113848E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the 2 front wiper arm head caps.


3. REMOVE FRONT WIPER ARM LH
  1. Operate the wiper, then stop the windshield wiper motor in the automatic stop position.

  1. E113850
    Remove the nut and front wiper arm.


4. REMOVE FRONT WIPER ARM RH

HINT:
Use the same procedure as for the LH side.


5. REMOVE HOOD TO COWL TOP SEAL

E113851
  1. Disengage the 7 clips and remove the hood to cowl top seal.


6. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for LHD)

E117641
  1. Disengage the 2 hooks and remove cowl top ventilator louver center No. 1.

  1. E113852
    Disconnect the washer hose.

  1. Disengage the 11 claws and clip.

  1. E113854
    Disconnect the washer hose and remove the cowl top ventilator louver sub-assembly.


7. REMOVE COWL TOP VENTILATOR LOUVER LH (for LHD)

E113853
  1. Remove the 2 clips.

  1. Disengage the 4 claws and remove the cowl top ventilator louver LH.


8. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (for RHD)

E113855
  1. Disconnect the washer hose.

  1. Disengage the 10 claws and clip and remove the cowl top ventilator louver sub-assembly.


9. REMOVE COWL TOP VENTILATOR LOUVER LH (for RHD)

E113856
  1. Remove the clip.

  1. Disengage the 4 claws and remove the cowl top ventilator louver LH.


10. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY

E113857
  1. Remove the 2 bolts.

  1. Slide the wiper link. Disengage the meshing of the rubber pin, then disconnect the connector and remove the front wiper motor and link.


11. REMOVE COWL TO REGISTER DUCT SUB-ASSEMBLY NO. 2

  1. A118801E01
    Disengage the claws and remove cowl to resister duct No. 2.


12. REMOVE COWL TOP PANEL OUTER

  1. A131386
    Disengage the clamp and separate the wiper motor connector.

  1. A131385
    Remove the 9 bolts and the cowl top panel outer.


13. REMOVE ECM

A136451E01
  1. Push the lock button while slightly pushing portion A of the lever of the ECM connector, and turn the lever until it makes a click sound.

    NOTICE:
    Do not turn the lever before pushing the lock button to avoid breakage of the spring of the lock button.

  1. A127395
    Disconnect the 2 ECM connectors.

  1. A127396
    Remove the bolt, 2 nuts and ECM.


14. REMOVE ECM BRACKET

  1. A127397
    Remove the 2 screws and remove the ECM bracket.


15. REMOVE ECM BRACKET NO. 2

  1. A127398
    Remove the 2 screws and ECM bracket No. 2.

← COMPONENTS (from Nov 2005)INSTALLATION (from Nov 2005) →