2005-2008 Yaris · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built from Nov 2005


1. INSTALL CAM POSITION SENSOR
  1. Install a new O-ring onto the cam position sensor.

  1. F048848
    Install the cam position sensor onto the vacuum pump.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }


2. INSTALL VACUUM PUMP

F048854
  1. Coat 2 new O-rings with engine oil, and place them onto the vacuum pump.

  1. F048844
    Apply engine oil to the oil pipe at the tip of the vacuum pump.

  1. C129750E01
    Install the vacuum pump so that the coupling teeth A on the side of the vacuum pump can engage with the tip groove of camshaft B.

  1. C129749
    Install 2 new bolts onto the vacuum pump.

    Torque:
    21 N*m{ 214 kgf*cm , 16 ft.*lbf }

  1. C129748
    Connect the vacuum hose with the clip to the vacuum pump.

  1. Connect the cam position sensor connector.


3. INSPECT VACUUM PUMP

C129747E01
  1. Disconnect the vacuum hose and connect the vacuum gauge to the vacuum pump.

  1. Start the engine.

  1. Measure the vacuum with the engine at idle.

    Vacuum at standard (sea-level) atmospheric pressure (1,013 mbar) when 2 minutes or more have elapsed after the engine is started:
    More than 86 kpa (650 mmHg)

    HINT:
    Replace the vacuum pump every 200,000 km (124,000 miles).

← REMOVAL (from Nov 2005)COMPONENTS (from Jan 2006) →