INSTALLATION
Removal / installation · Vehicles built from Nov 2005
| 1. INSTALL ENGINE OIL LEVEL SENSOR |
Install the engine oil level sensor with the 4 bolts.

- Torque:
- 7.0 N*m{ 71 kgf*cm , 62 in.*lbf }
Connect the connector.

| 2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 5.4 N*m{ 55 kgf*cm , 48 in.*lbf }
| 3. ADD ENGINE OIL |
Fill the engine oil with fresh engine oil.
- Capacity:
Item
Capacity
Drain and refill with oil filter change
4.3 liters (4.5 US qts, 3.8 lmp. qts)
Drain and refill without oil filter change
3.8 liters (4.0 US qts, 3.3 lmp. qts)
Dry fill
4.8 liters (5.1 US qts, 4.2 lmp. qts)
| 4. CHECK FOR ENGINE OIL LEAKAGE |
| 5. CHECK ENGINE OIL LEVEL |
Warm up the engine. Then stop the engine, and wait 5 minutes.
Check that the engine oil level is between the 2 marks on the oil level gage.
If low, check for leakage and top up oil to the upper mark.- NOTICE:
- Do not add engine oil to above the upper mark.
| 6. INSTALL ENGINE UNDER COVER |
![]() ![]() |
Engage the 4 pins and install engine cover No. 1.

