REMOVAL
Removal / installation · Vehicles built from Nov 2005
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE ENGINE UNDER COVER |
Remove the 5 bolts, 4 screws and 2 clips and remove the engine under cover.
| 3. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil drain plug, and drain the oil into a container.
Clean and install the oil drain plug with a new gasket.
- Torque:
- 38 N*m{ 387 kgf*cm , 28 ft.*lbf }
| 4. REMOVE ENGINE OIL LEVEL SENSOR |
![]() ![]() |
Disconnect the connector.
Remove the 4 bolts and remove the engine oil level sensor.


