INSPECTION MODE PROCEDURE
Troubleshooting · Vehicles built from Nov 2005
| INSPECTION MODE PROCEDURE (for Using a Intelligent Tester) |
Turn the ignition switch off.

Connect the intelligent tester to the DLC3.
Turn the ignition switch on.
Switch the skid control ECU to test mode using the intelligent tester.
Select the following menu items: Chassis / ABS/VSC/TRC / Utility / Inspection Mode.Check that the slip indicator light comes on.
- HINT:
- To terminate inspection mode, use the intelligent tester or turn the ignition switch off.
| INSPECTION MODE PROCEDURE (for not Using a Intelligent Tester) |
Start the engine, and then wait for 30 seconds or more.
Apply the parking brake pedal, release the parking brake. Then, repeat the application and release of the parking brake twice or more, and stop the operation with the parking brake applied and perform the next step within 15 seconds.
While depressing the brake pedal, release the parking brake. Then, repeat the application and release of the parking brake twice or more, and stop the operation with the parking brake applied and perform the next step within 15 seconds.
While the parking brake is applied, depress the brake pedal twice or more.
Check that the slip indicator light comes on.
- HINT:
- To terminate inspection mode, turn the ignition switch off.