REASSEMBLY
Removal / installation · Vehicles built from Jan 2006
- CAUTION:
- Wear protective gloves. Sharp surfaces on the rear seatback frame could cause injuries to your hands.
| 1. INSTALL REAR SEATBACK LOCK ASSEMBLY |
w/ Cancel Function:

Install the rear seatback lock with the 2 bolts.
- Torque:
- 19.1 N*m{ 195 kgf*cm , 14 ft.*lbf }
w/o Cancel Function:

Install the rear seatback lock with the 2 bolts.
- Torque:
- 19.1 N*m{ 195 kgf*cm , 14 ft.*lbf }
| 2. INSTALL REAR SEATBACK FRAME SUB-ASSEMBLY |
Install the rear seatback frame.

Using hog ring pliers, install 9 new hog rings as shown in the illustration.

| 3. INSTALL REAR SEATBACK STOP BUTTON GROMMET (for 2 Point Type Rear Center Seat Belt) |
Engage the 2 claws and install the rear seatback button grommet.

| 4. INSTALL REAR SEAT HEADREST SUPPORT |
w/ Rear Center Seat Headrest:

Engage the 2 claws and install the rear seat headrest support.
- HINT:
- Use the same procedure to install the 4 rear seat headrest supports.
w/o Rear Center Seat Headrest:
Engage the 2 claws and install the rear seat headrest support.
- HINT:
- Use the same procedure to install the 2 rear seat headrest supports.
| 5. INSTALL CUP HOLDER ASSEMBLY |
Engage the 4 claws and install the rear seat cup holder.

| 6. INSTALL REAR SEAT CENTER ARMREST HINGE |
Install the rear seat center armrest hinge with the 2 bolts and the 2 spacers.

- Torque:
- 21 N*m{ 215 kgf*cm , 16 ft.*lbf }
| 7. INSTALL REAR SEAT CENTER ARMREST HINGE COVER |
Engage the 3 claws and install the rear seat center armrest hinge cover.

| 8. INSTALL REAR SEAT CENTER ARMREST ASSEMBLY |
Install the rear seat center armrest with the 2 nuts and the 2 wave washers.

- Torque:
- 33 N*m{ 335 kgf*cm , 24 ft.*lbf }
Install the rear seatback cover with the 7 clips.

| 9. INSTALL REAR SEATBACK LOCK CONTROL BEZEL (w/ Cancel Function) |
Engage the 2 claws and install the rear seatback lock control bezel.

| 10. INSTALL REAR CENTER SEAT SHOULDER BELT GUIDE (for 3 Point Type Rear Center Seat Belt) |
Insert the pin into the rear seatback frame hole and install the rear seat center shoulder belt guide with the 2 screws.

| 11. INSTALL REAR SEATBACK LOCK RELEASE BUTTON |
Install the rear seatback lock release button.

| 12. INSTALL REAR SEAT SHOULDER BELT GUIDE |
Insert the pin into the rear seatback frame hole and install the rear seat shoulder belt guide with the 2 screws.

| 13. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY (w/ Rear Center Seat Headrest) |
Push the lock button of the rear center seat headrest support and install the rear center seat headrest.

| 14. INSTALL REAR SEAT HEADREST ASSEMBLY |
Push the lock button of the rear seat headrest support and install the rear seat headrest.

