2005-2008 Yaris · Service Manual HEATER & AIR CONDITIONING SYSTEM

DIAGNOSIS SYSTEM

Troubleshooting · Vehicles built from Nov 2005

NOTICE:
The cause of failures (such as abnormal voltage, overheat, a short-circuit, breakage of functional components, etc.) and repair methods are shown by connecting the DTC tester and reading DTCs.


DIAGNOSTICS FUNCTION
  1. Connect connector A of the DTC tester to the vehicle wire harness, and connector B of the DTC tester to the power heater connector.

  2. Start the engine.

  3. Pressing the DTC calling button displays a 3-digit number DTC.
    E124452E01


DESCRIPTION OF DISPLAY AND BUTTONS
  1. AF: Current Malfunction (Blinking in the event of a current malfunction)
  2. Diag: DTC (Example: 064 Flame sensor break)
  3. Memory Clear Buttons: Clear DTC memory (Press both buttons together for more than 2 seconds.)
  4. > Button: Scrolls up DTC memory (The 5 history codes can be stored.)
  5. < Button: Scrolls down DTC memory (The 5 history codes can be stored.)

FAULTY MEMORY
  1. The ECU is able to store up to 5 DTCs in the memory. If it is full, new data is written over F5.


FAIL-SAFE
  1. If the glow plug breaks, the ECU detects the breakage and stops the automatic operation to prevent burner heater operation.

← TERMINALS OF ECU (from Nov 2005)DIAGNOSTIC TROUBLE CODE CHART (from Nov 2005) →