2005-2008 Yaris · Service Manual HEATER & AIR CONDITIONING SYSTEM

010 Over Voltage Shutoff

Diagnostic trouble codes · Vehicles built from Nov 2005

Also covers:

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
010
Battery voltage is 14 V or more for 20 seconds or more.
  1. Wire harness or connector between combustion heater assembly and battery
  2. Battery
  3. Generator (Alternator)
  4. Combustion heater assembly
011
Battery voltage is 10 V or less for 20 seconds or more.

WIRING DIAGRAM

E126898E01

INSPECTION PROCEDURE

HINT:
Before performing the following procedures, check the battery and generator (alternator) and confirm that they are operating normally (Click herefor the battery, Click here for the generator (alternator)).


1. INSPECT FUSE (H-LP CLN/PWR HTR)

  1. E126899E01
    Remove the H-LP CLN/PWR HTR fuse from the engine room R/B and J/B.

  1. Measure the resistance.

    Standard resistance:
    Inspection item
    Specified condition
    H-LP CLN/PWR HTR fuse
    Below 1 Ω



NG
REPLACE FUSE (H-LP CLN/PWR HTR)
OK


2. CHECK HARNESS AND CONNECTOR (COMBUSTION HEATER ASSEMBLY)

  1. E124456E07
    Disconnect the A52 connector from the combustion heater assembly.

  1. Measure the voltage and resistance.

    Standard voltage:
    Tester connection
    (Symbols)
    Specified condition
    A52-5 (B) - Body ground
    10 to 14 V

    Standard resistance:
    Tester connection
    (Symbols)
    Specified condition
    A52-1 (E) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBUSTION HEATER ASSEMBLY


← DIAGNOSTIC TROUBLE CODE CHART (from Nov 2005)012 Overheating (+ 014, 017) (from Nov 2005) →