2005-2008 Yaris · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Jan 2006


1. INSTALL OUTER MIRROR COVER

  1. B136243
    Engage the claw on the lower part of the mirror cover.

  1. Engage the claw on the upper part of the mirror cover.

  1. After installing the outer mirror cover, check that there are no gaps between the cover and the mirror body.

    NOTICE:
    If there is a gap between the cover and the mirror body, it may cause noise during driving.

  1. B136244
    Engage the 2 claws of the outer rear view mirror.

  1. Engage the 2 clips and install the mirror.


2. INSTALL OUTER REAR VIEW MIRROR

B136162E01
  1. Engage the claw and install the outer rear view mirror with the 3 nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. w/ Power mirror:
    Connect the connector.


3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

  1. B136161
    w/ Power window:

    1. Connect the front door lock remote control cable and front door inside locking cable.

    2. B136160
      Engage the 9 clips and install the front door trim board.

    3. B136159
      Tighten the screw.

  1. w/o Power window:

    1. B136194
      Connect the front door lock remote control cable and front door inside locking cable.

    2. B136192
      Engage the 9 clips and install the front door trim board.

    3. B136193
      Tighten the screw.


4. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

B136157E01
  1. Engage the claw and clip and install the front door lower frame bracket garnish.


5. INSTALL FRONT ARMREST BASE UPPER PANEL

B136158
  1. for Driver side with power window:

    1. Connect the connector.

    2. Engage the 7 claws and 2 clips and install the front armrest base upper panel.

    3. Tighten the screw.

  1. B140702
    for Front passenger side with power window:

    1. Connect the connector.

    2. Engage the 7 claws and 2 clips and install the front armrest base upper panel.

    3. Tighten the screw.

  1. B136191
    w/o Power window:

    1. Engage the 5 clips and 2 clips and install the front armrest base upper panel.

    2. Tighten the screw.


6. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

B136196E01
  1. Install the window regulator handle plate.

  1. Open all the windows.

  1. B129030E01
    Install the front door window regulator handle with the clip at the angle shown in the illustration.


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

← INSPECTION (from Jan 2006)COMPONENTS (from Aug 2005) →