SERVICE DATA
Specifications · Vehicles built from Nov 2005
| Battery |
Standard specific gravity: |
1.25 to 1.29 at 20°C (68°F) |
|
| Charging circuit without load |
Standard amperage |
10 A or less |
|
| Standard voltage |
13.2 to 14.8 V |
||
| Charging circuit with load |
Standard amperage |
30 A or more |
|
| Generator rotor assembly resistance |
Slip rings |
1.8 to 2.8 Ω at 20°C (68F°) |
|
| Slip rings and rotor |
10 kΩ or higher |
||
| Generator rotor assembly slip ring diameter |
Standard diameter |
15.3 to 15.5 mm (0.602 to 0.610 in.) |
|
| Minimum diameter |
14.9 mm (0.587 in.) |
||
| Starter sub-assembly generator with rectifier |
Positive rectifier |
Positive (+) tester probe - Positive (+) terminal |
Below 1 Ω |
| Negative (-) tester probe - Rectifier terminal | |||
| Negative (-) tester probe - Positive (+) terminal |
10 Ωor higher |
||
| Positive (+) tester probe - Rectifier terminal | |||
| Negative rectifier |
Positive (+) tester probe - Negative (-) terminal |
10 Ωor higher |
|
| Negative ( ) tester probe Rectifier terminal | |||
| Negative (-) tester probe - Negative (-) terminal |
Below 1 Ω |
||
| Positive (+) tester probe - Rectifier terminal | |||
| Starter for open circuit |
Between rectifier terminals |
Below 1 Ω |
|
| Generator brush holder assembly |
Exposed length |
13.2 mm (0.520 in.) |
|
| Minimum exposed length |
6.0 mm (0.236 in.) |
||