2005-2008 Yaris · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built from Jan 2006

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/front seat side airbag) (Click here).

NOTICE:
Always use "Torx" socket wrench E10 when installing the front seat.

HINT:
The procedure described below is for the driver side of LHD. Use the same procedure for both the front passenger and driver sides of LHD, unless otherwise specified.


1. INSTALL FRONT SEAT INNER BELT ASSEMBLY

  1. B138355E01
    Install the front seat inner belt with the nut.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not place the front seat inner belt over the convex areas of the front seat adjuster frame.

  1. Install the wire harness into the claw of the front seat cushion inner shield.

  1. B138350
    for Driver Side:

    1. Install the 3 clamps.

    2. Engage the claw and install the connector.

  1. B138353
    for Front Passenger Side:

    1. Install the 3 clamps.

    2. Engage the claw and install the connector.

    3. Connect the occupant detection sensor connector.


2. INSTALL FRONT SEAT ASSEMBLY

B138318E01

NOTICE:
Follow the procedure described below in order to prevent the seat tracks from locking separately.

  1. Insert the 2 locating pins through the 2 body holes, place the front seat in the most forward position, and then make sure that the inner and outer seat tracks are locked securely.

  1. Using "Torx" socket wrench E10, tighten bolt 1 and then bolt 2 on the rear side.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Move the front seat to the most rearward position, and then make sure that the inner and outer seat tracks are locked securely.

  1. Using "Torx" socket wrench E10, tighten bolt 3 and then bolt 4 on the front side.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

    HINT:
    If the inner and outer seat tracks do not lock simultaneously, loosen the bolts and adjust the seat tracks.

  1. B138316
    w/ Front Seat Side Airbag:

    1. Connect the airbag connector.

  1. Connect the buckle switch connector.


3. INSTALL FRONT SEAT HEADREST ASSEMBLY

  1. B138314E01
    Push in the lock button of the front seat headrest support and install the front seat headrest.


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


5. INSPECT SRS WARNING LIGHT (w/ Front Seat Side Airbag)
(Click here)
← INSPECTION (from Jan 2006)COMPONENTS (from Aug 2005) →