2005-2008 Yaris · Service Manual ENGINE

REPLACEMENT

Removal / installation · Vehicles built from Nov 2006


1. REPLACE RING PIN

NOTICE:
It is not necessary to remove the ring pins unless they are being replaced.

  1. A151025E02
    Using a plastic hammer, tap in the ring pins.

    Standard protrusion:
    7.5 to 8.5 mm (0.295 to 0.335 in.)


2. REPLACE STUD BOLT

NOTICE:
If a stud bolt is deformed or the threads are damaged, replace it.

  1. A151026E01
    Using "TORX" socket E6, install the stud bolt as shown in the illustration.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }


3. REPLACE STRAIGHT PIN

NOTICE:
It is not necessary to remove the straight pins unless they are being replaced.

  1. Using a plastic hammer, tap in the straight pin.

    A151027E01

    Standard protrusion:
    Item
    Protrusion
    Pin A
    18.5 to 19.5 mm (0.729 to 0.768 in.)
    Pin B
    5.0 to 7.0 mm (0.197 to 0.276 in.)
    Pin C
    11.0 to 13.0 mm (0.433 to 0.512 in.)
    Pin D
    5.0 to 7.0 mm (0.197 to 0.276 in.)
    Pin E
    5.0 to 6.0 mm (0.197 to 0.236 in.)

← INSPECTION (from Nov 2006)REASSEMBLY (from Nov 2006) →