2005-2008 Yaris · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2006


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN ENGINE COOLANT

NOTICE:
To avoid the danger of being burned, do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap sub-assembly.

  1. Loosen the cylinder block drain cock plug, then drain the coolant.

    A147622E02


3. REMOVE NO. 2 CYLINDER HEAD COVER

  1. A163755
    Disengage the 2 fittings shown in the illustration.

  1. A163756
    Disengage the 2 fittings shown in the illustration, then remove the No. 2 cylinder head cover.


4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH HOSE

  1. A159377
    Disconnect the wire harness clamp and mass air flow meter connector.

  1. A159378
    Disconnect the No. 2 ventilation hose.

  1. A159379
    Loosen the hose clamp, unlock the 2 clamps and remove air cleaner cap sub-assembly with hose.


5. REMOVE THROTTLE BODY ASSEMBLY

  1. A158231
    Disconnect the throttle body connector.

  1. A158232
    Disconnect the water by-pass hose and the No. 2 water by-pass hose.

  1. A158233
    Remove the 2 bolts and 2 nuts and remove the throttle body assembly.

  1. A158234
    Remove the gasket from the intake manifold.

← ON-VEHICLE INSPECTION (from Nov 2006)INSPECTION (from Nov 2006) →