AIR CONDITIONING UNIT (for Sedan) > REASSEMBLY |
| 1. INSTALL NO. 1 COOLER THERMISTOR |
![]() |
Install the sensor onto the evaporator as shown in the illustration.
Check that the sensor sticks to the evaporator surface as shown in the illustration (A: Sensor, B: Evaporator).
| 2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY |
![]() |
Install the cooler evaporator.
![]() |
Engage the 4 claws and install the heater case lower.
Install the 3 screws.
![]() |
Engage the cooler thermistor connector.
| 3. INSTALL COOLER EXPANSION VALVE |
![]() |
Apply sufficient compressor oil (ND-OIL8) to 2 new O-rings and the fitting surface of the cooler expansion valve.
Install the 2 O-rings onto the cooler evaporator.
Using a hexagon wrench 4, install the cooler expansion valve with the 2 hexagon bolts.
| 4. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY |
![]() |
Install the heater radiator unit onto the air conditioner radiator assembly.
![]() |
Engage the 3 clips and install the clamp.
| 5. INSTALL NO. 2 AIR DUCT |
![]() |
Engage the 3 claws and install the air duct.
| 6. INSTALL NO. 1 AIR DUCT |
![]() |
Engage the 3 claws and install the air duct.
| 7. INSTALL AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY |
![]() |
Engage the claw and install the air mix damper control cable.
| 8. INSTALL DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY |
![]() |
Engage the claw and install the defroster damper control cable.