DTC P0787 Shift / Timing Solenoid Low (Shift Solenoid Valve ST) |
DTC P0788 Shift / Timing Solenoid High (Shift Solenoid Valve ST) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0787 | ECM detects short in solenoid valve ST circuit 4 times when solenoid valve ST is operated. (1-trip detection logic) |
|
| P0788 | ECM detects open in solenoid valve ST circuit 4 times when solenoid valve ST is not operated. (1-trip detection logic) |
|

| 1.INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE ST) |
![]() |
Disconnect the transmission wire connector from the transaxle.
Measure the resistance.
| Tester Connection | Specified Condition |
| 2 (ST) - Body ground | 11 Ω to 15 Ω at 20°C (68°F) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM) |
![]() |
Connect the transmission connector to the transaxle.
Disconnect the ECM connector.
Measure the resistance.
| Tester Connection | Specified Condition |
| 80 (ST) - Body ground | 11 Ω to 15 Ω at 20 °C (68 °F) |
|
| ||||
| OK | ||
| ||
| 3.INSPECT SHIFT SOLENOID VALVE ST |
![]() |
Remove shift solenoid valve ST.
Measure the resistance.
| Tester Connection | Specified Condition |
| Solenoid Connector (ST) - Solenoid Body (ST) | 11 to 15 Ω at 20 °C (68 °F) |
Connect the positive (+) lead to the terminal of the solenoid connector and the negative (-) lead to the solenoid body to check the solenoid valve operation.
|
| ||||
| OK | ||
| ||