Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM (for Sedan)

ANTI-LOCK BRAKE SYSTEM (for Sedan) > TERMINALS OF ECU

for Preparation Click here



Terminals of ECU

C110609E01


Skid Control ECU: 
Symbols (Terminals No.)
Terminal Description
+BS (A15-1)
Solenoid valve power supply
GND1 (A15-2)
Skid control ECU ground
CANL (A15-5)
CAN communication line L
CANH (A15-6)
CAN communication line H
FL- (A15-8)
Front LH wheel speed signal input
FL+ (A15-9)
Front LH wheel speed sensor power supply
STP (A15-10)
Stop light switch input
RL+ (A15-11)
Rear LH wheel speed sensor power supply
RL- (A15-12)
Rear LH wheel speed signal input
+BM (A15-23)
Motor relay power supply
GND2 (A15-24)
Actuator pump motor ground
IG1 (A15-25)
ECU power supply
SP1 (A15-26)
Speed signal output for speedometer
FR- (A15-30)
Front RH wheel speed signal input
FR+ (A15-31)
Front RH wheel speed sensor power supply
RR+ (A15-33)
Rear RH wheel speed sensor power supply
RR- (A15-34)
Rear RH wheel speed signal input

E114510E04


Main Body ECU: 
Symbols (Terminals No.)
Terminal Description
PKB (4C-2)
Parking brake switch input

Terminal inspection


  1. Disconnect the connector and measure the resistance and voltage on the wire harness side.

    HINT:
    The voltage cannot be measured with the connector connected to the skid control ECU as the connector is water resistant.


    C107496E01


    Skid Control ECU: 
    Symbols
    Wiring Color
    Terminal Description
    Conditions
    Specified Conditions
    +BS (A15-1) - Body ground
    W - Body ground
    Solenoid valve power supply
    Always
    11 to 14 V
    GND1 (A15-2) - Body ground
    W-B - Body ground
    Skid control ECU ground
    Always
    Below 1 Ω
    STP (A15-10) - Body ground
    G - Body ground
    Stop light switch input
    Stop light switch ON
    Brake pedal depressed
    11 to 14 V
    STP (A15-10) - Body ground
    G - Body ground
    Stop light switch input
    Stop light switch OFF
    Brake pedal released
    Below 1.5 V
    +BM (A15-23) - Body ground
    B - Body ground
    Motor relay power supply
    Always
    11 to 14 V
    GND2 (A15-24) - Body ground
    W-B - Body ground
    Actuator pump motor ground
    Always
    Below 1 Ω
    IG1 (A15-25) - Body ground
    B - Body ground
    ECU power supply
    Ignition switch ON
    11 to 14 V

    C118700E01


    Main Body ECU: 
    Symbols
    Wiring Color
    Terminal Description
    Conditions
    Specified Conditions
    PKB (4C-2) - Body ground
    Y - Body ground
    Parking brake switch input
    Parking brake switch ON
    Below 1 Ω
    PKB (4C-2) - Body ground
    Y - Body ground
    Parking brake switch input
    Parking brake switch OFF
    10 kΩ or higher