BRAKE SYSTEM (for Sedan) > ADJUSTMENT |
| 1. INSPECT AND ADJUST BRAKE PEDAL |
Remove the instrument panel under tray .
![]() |
Inspect the brake pedal height.
| w/ABS | w/o ABS |
| 107.3 to 117.3 mm (4.224 to 4.618 in.) | 107.8 to 117.8 mm (4.244 to 4.638 in.) |
Adjust the brake pedal height.
Disconnect the connector from the stop light switch.
Turn the stop light switch counterclockwise, and remove the stop light switch.
Loosen the push rod lock nut.
Adjust the pedal height by turning the pedal push rod.
| w/ABS | w/o ABS |
| 107.3 to 117.3 mm (4.224 to 4.618 in.) | 107.8 to 117.8 mm (4.244 to 4.638 in.) |
Tighten the push rod lock nut.
![]() |
Insert the stop light switch into the adjuster until it just touches the brake pedal.
![]() |
Make a quarter turn clockwise to install the stop light switch.
Check the stop light switch clearance.
Connect the connector to the stop light switch.
![]() |
Inspect the brake pedal free play.
Stop the engine and depress the brake pedal several times until there is no vacuum left in the booster.
Push in the pedal until the beginning of the resistance is felt. Measure the distance as shown.
![]() |
Inspect the brake pedal reserve distance.
Release the parking brake lever. With the engine running, depress the pedal and measure the pedal reserve distance as shown.
| LHD | RHD | |
| w/ ABS | More than 73 mm (2.87 in.) | More than 74 mm (2.91 in.) |
| w/o ABS | More than 70 mm (2.75 in.) | - |
Install the instrument panel under tray .