BRAKE SYSTEM (for Sedan) > ON-VEHICLE INSPECTION |
| 1. INSPECT BRAKE BOOSTER |
![]() |
Check the airtightness.
Start the engine and stop it after 1 or 2 minutes. Depress the brake pedal several times slowly.
Depress the brake pedal while the engine is running, and stop the engine with the pedal depressed.
![]() |
Check the operation.
Depress the brake pedal several times with the engine stopped and check that there is no change in the pedal reserve distance.
Depress the brake pedal and start the engine.
| 2. INSPECT VACUUM CHECK VALVE |
Check the vacuum check valve.
Slide the clip and disconnect the vacuum hose.
Remove the vacuum check valve from the brake booster.
![]() |
Check that there is ventilation from the booster to the engine, and no ventilation from the engine to the booster.
If any fault is found, replace the vacuum hose assembly.
Install the vacuum check valve onto the brake booster.
Connect the vacuum hose with the clip.
| 3. INSPECT PROPORTIONING VALVE (w/o ABS) |
Remove the bleeder plug from the front brake caliper and rear wheel cylinder.
Install SST and then bleed the air.

Raise the front brake caliper pressure and inspect the rear wheel cylinder pressure.
| Front Brake Caliper Pressure | Rear Wheel Cylinder Pressure |
| 1,500 kPa (15.3 kgf/cm2, 218 psi) | 1,500 kPa (15.3 kgf/cm2, 218 psi) |
| 5,000 kPa (51.0 kgf/cm2, 725 psi) | 2,350 kPa (24.0 kgf/cm2, 341 psi) |
| 8,000 kPa (81.6 kgf/cm2, 1,160 psi) | 3,100 kPa (31.6 kgf/cm2, 450 psi) |
Remove SST.
Install the bleeder plug onto the front brake caliper and rear wheel cylinder.
Bleed the brake fluid (Click here).
Check the brake fluid leakage.