HOOD (for Hatchback) > ADJUSTMENT |

| 1. INSPECT HOOD |
Check that the clearance measurements are within the standard ranges.

| Area | Measurement | Area | Measurement |
| A | 1.7 to 5.7 mm (0.067 to 0.224 in.) | G | -1.55 to 2.45 mm (-0.061 to 0.096 in.) |
| B | -2 to 2 mm (-0.079 to 0.079 in.) | H | 1.75 to 5.75 mm (0.067 to 0.226 in.) |
| C | 4.45 to 10.45 mm (0.175 to 0.411 in.) | I | -1.25 to 2.75 mm (-0.049 to 0.108 in.) |
| D | -0.95 to 5.05 mm (-0.037 to 0.199 in.) | J | -1.5 to 1.5 mm (-0.059 to 0.059 in.) |
| E | 7.55 to 13.55 mm (0.297 to 0.533 in.) | K | 2.0 to 5.0 mm (0.079 to 0.197 in.) |
| F | 1.65 to 5.65 mm (0.065 to 0.222 in.) | - | - |
| 2. ADJUST HOOD |
![]() |
Loosen the hood side hinge bolts.
Move the hood to adjust the clearance to within the standard range.
Tighten the hood side hinge bolts after the adjustment.
![]() |
Adjust the height of the hood front end by turning the cushion rubber.
![]() |
Adjust the hood lock.
Loosen the 3 bolts.
Adjust the hood lock position so that the striker can enter it smoothly.
Tighten the 3 bolts after the adjustment.