SFI SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC (Using an intelligent tester) |
![]() |
Connect an intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / DTC.
Check the DTC(s) and freeze frame data, and then write them down.
Check the details of the DTC(s).
| CLEAR DTC (Using an intelligent tester) |
Connect an intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / DTC / Clear.
Press the YES button.
| CLEAR DTC (Without using an intelligent tester) |
Perform either of the following operations.
Disconnect the negative battery cable for more than 1 minute.
Remove the EFI and ETCS fuses from the engine room relay block located inside the engine compartment for more than 1 minute.