SFI SYSTEM > CHECK MODE PROCEDURE |
| CHECK MODE PROCEDURE (Using an intelligent tester) |
![]() |
Check and ensure the following conditions:
Battery positive voltage 11 V or more.
Throttle valve fully closed.
Transmission in the P or N positions.
A/C switch off.
Turn the ignition switch off.
Connect an intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Select the following menu items: Utility / Check Mode.
Switch the ECM from normal mode to check mode.
![]() |
Make sure the MIL flashes as shown in the illustration.
Start the engine.
Make sure the MIL turns OFF.
Simulate the conditions of the malfunction described by the customer.
Check DTCs and freeze frame data using the tester.